Error detection

The SPI-Bus can be used in 2 different error detection kinds:

• Parity error detection
  (Settings of the parity parameter)
  
• CRC error detection
  (Settings of the CRC parameter)
  

The settings depends on which error detection is supported from the sensors (data sheet of the manufacturer)

The settings are done at the SPI-Bus-Configuration window.

Parity-Mode	The parity mode is set by the parameter Parity and selection of the parity parameters at once.
CRC-Mode	The CRC mode is set by the parameter Parity = CRCt. The detailed settings of the parameter are done at the SPI-Bus configuration window at the section CRC-Configuration.
No error detection	If there is no error detection in use, the parameter Parity has to be set on OFF.