Simulyzer Settings

The settings of the communication between sensor to ECU and their parameter are done by the following steps:

• Automatically - by selection of an according project.

• Manual - by following steps:

1. Definitions of the connected sensors
2. Definitions of the single timeslots of each signal
3. Definition of the signals with assignment to the sensor timeslot
4. Definition of the data section A.
5. Further individual parameter definitions.

The assignment of the defined sensors and their time slots to the defined signals occurred by the assignment of their index number.

Procedure:

• Define the sensors in the sensor signal list editor - mandatory

• Define a timeslots - mandatory

• Define the sensor signals - mandatory

• Define data section A - mandatory

• Define data section B - optional

• Define state section - optional

• Define frame control - optional

• Define messaging bit- optional